1. O conector da válvula solenóide Ross está solto ou cai e a válvula solenóide não é carregada . o conector pode ser apertado .
{{0}} When the solenoid valve coil is burned, the solenoid valve wiring can be removed and detected with a multimeter. If the circuit is open, the solenoid coil is burned. The reason is that the coil is damp, insulation is poor, magnetic leakage, the current in the coil is too large, and it is burnt fora . A água da chuva deve ser impedida de entrar na válvula solenóide . Além disso, se a mola for muito difícil, a força de reação é grande, o número de voltas da bobina é muito pequeno, e a força de sucção é insuficiente, a bobina será queimada "de 5}}, de caso de emergência," Posição .
3. A válvula solenóide está presa . a folga entre a luva deslizante da válvula solenóide e o núcleo da válvula é pequeno (menor que 0 . 008mm) . é geralmente montado em um todo. quando se mecânica, há pouco.} ou mais. quando se mecânica, é que há muito, que há muito {4}. {4 {4} {4} {4} {4} {4} {4} {4} {4}. {4}. é geralmente montado em um inteiro . quando se mecânica. block. This solution can be used to pierce a small hole in the head with a steel wire to make it rebound. The fundamental solution is to remove the solenoid valve, remove the valve core and spool sleeve, and clean with CCI4, so that the valve core can move flexibly in the valve sleeve. During disassembly, attention should be paid to the assembly sequence and external wiring position of Cada parte, de modo a facilitar a montagem e a fiação corretas e verificar se o orifício da injeção de combustível está bloqueado e se o óleo lubrificante é suficiente.
4. Leakage. The solenoid valve will cause insufficient air pressure, so that the forced valve can not be opened and closed. The reason is that the gasket is damaged or the sliding valve is worn, resulting in multiple cavities escaping. When solving the system fault of solenoid valve in the conversion system, we should select a reasonable time to Lidar com isso quando a válvula solenóide é desligada . Se o processo não for implementado em uma lacuna de comutador de controle, o sistema de comutação de controle pode ser interrompido e resolvido pacificamente .
